Expert Answers about Keystone Passport Ultra Lite Elite Travel Trailer

• Replacement Brakes on a 3,000 lb. Axle
• While it may be possible that a 3,500 lb. brake assembly will fit your 3,000 lb. axle, it is recommended that you stay with the 3,000 lb. size intended for your axle and use the part number # K23-472-473-00 for a replacement. If you are dead set on using a 3,500 lb. brake assembly you would need to measure your bearings and brake flange to determine if there is a hub that fits.
  view full answer...


• Correct SolidSteps for 25 Inch Wide x 34 Inch High Entry Door on RV
• Thanks so much for the photos they were super helpful, and based on those we do have the exact Lippert SolidSteps you need. Since your doorway width is just over 25 inches and entry height is just over 34 inches the correct SolidStep is the following: - SolidStep Manual Fold-Down Steps # LC791572 These steps will fit doors with your width and entry height, though the stabilizer you are referring to will likely need to be removed as it juts out too far. I have added links to the instructions...
  view full answer...


• Correct SumoSprings for Keystone Passport Elite Travel Trailer 4,400 Lb Axles
• The correct SumoSprings Trailer Helper Springs for overslung axles (axle under leaf springs) is part # TSS-107-40. The springs will be pre-loaded upon installation therefore the space you have between the frame is spring loaded will be less than the height of the spring and bracket. This won't be an issue.
  view full answer...


• How to Determine Correct Trailer Hub
• It's possible we have a hub for your TeeNee trailer, though we don't have any way of knowing off-hand or cross-referencing what hubs you need. So in order to find the correct hubs you will need to take apart your current hub assembly and look at the bearings themselves; wipe away the grease and you should be able to see the part number stamped directly on them. If you are unable to find them, you need to use a digital caliper and measure your spindle where the bearings ride, like in the...
  view full answer...


• Can the Same 14" Wheel Be Used for 6-Ply and 8-Ply Tires
• As long as the valve stem in your wheel can handle the higher 75 psi rating of the 8-ply Load Range D tire and you don't plan on exceeding the lower weight rating of your wheels then you'll be just fine. If you need to upgrade your valve stem as well then the Americana High Pressure Rubber Snap-In Valve Stem # AM20904 will get the job done since it is rated for up to 80 psi. If you'd rather have a wheel rated for up to 2,200 lbs (the max rating I'm seeing for an 8-ply tire) then you will...
  view full answer...


• How to Use Drill Adapter with Dutton-Lainson Hand Winch # DL14964
• That's actually a really good question and you aren't missing anything. To be able to add and use the Drill Drive Socket Adapter # DL6456 with the Dutton-Lainson Hand Winch # DL14964, you'll also need to replace the stock handle with part # DL6454. This will give you the square hub so that everything matches up.
  view full answer...